Group: rec.autos.makers.chrysler
Dodge, Plymouth, Jeep, Eagle, etc info/talk.
Add group to favorites
Back to group list
Send new message to group Search:
From: pmcc@iname,com - 01 Jul 2008, 22:29
Anybody know if there's any plans afoot to build a flex fuel Wrangler? I'd love to own one for use during the coming Buffalo winter, but the idea of giving OPEC more business is unappealing.
10 Posts. Last post send by: pmcc@iname,com - Tuesday 01 Jul
From: Lorenzo R. - 01 Jul 2008, 03:11
im in montreal quebec im selling a 300m special 2003 silver with black interior, 144k 18inch mags and spoiler with brand new 245/45/zr18 tire for 8500$ or concorde lx 2001 98k black with tan interior for 3800$ Lorenzo: 514-358-2573
0 Reply
From: kmath50@gmail,com - 30 Jun 2008, 22:45
Just saw on CNNMoney that Chrysler will close the South St. Louis plant. Isn't this where the Grand Caravans and Town & Countrys are all assembled? -KM
16 Posts. Last post send by: kmath50@gmail,com - Monday 30 Jun
From: fab4 via CarKB,com - 30 Jun 2008, 01:20
I'm getting a code P0420 ( Catalyst Efficiency Below Threshold) on my 1996 Plymouth Voyage Minivan. It has 160,000 miles with a 3.0 Engine. I was able to clear the "Check Engine Soon Light" with my code reader, but it keeps coming back after a couple of days. Now it stays on constantly, but can be cleared. I replace both the before and after oxygen sensors...
5 Posts. Last post send by: fab4 via CarKB,com - Monday 30 Jun
From: ks - 28 Jun 2008, 17:15
I have two new vehicles with Tire Pressure Monitor Systems, 2007 Jeep Compass and a 2008 Chrysler Town & Country. When I rotate the tires how to I reset the wheel location for the tire pressure monitoring system. The owners manual doesn't seem to discuss wheel location changes. Thanks Kevin
6 Posts. Last post send by: ks - Saturday 28 Jun
From: jaygreg - 28 Jun 2008, 14:48
My 2000 Chrysler Concorde LXi was found to need a right inner control arm according to a repair shop yesterday. I was told the job requires that the plenum be removed first. When I got home and plowed into my factory service manual I bought from Chrysler, I found the repair doesn’t require the removal of the plenum. A 1995 Concorde I owned had the same...
3 Posts. Last post send by: jaygreg - Saturday 28 Jun
From: geo.nova@hotmail,com - 27 Jun 2008, 01:44
Squealing sound from engine. Not constant....only happens in short bursts lasting a few seconds at a time but quite loud. Will a worn belt do this? Happens when AC is off as well as on. Thanks in advance for any help. K
0 Reply
From: geo.nova@hotmail,com - 27 Jun 2008, 01:32
Check engine light came on , checked flash code is 21-oxygen sensor. I went in to pick one up and guys asks which one, upstream or downstream? He says I have to take my car somewhere to have them both tested. I would like to know how much I should expect to pay for the tests and installation. I know the part will be either $53 or $73. Also, does anyone know...
0 Reply
From: Norm II - 26 Jun 2008, 11:08
Wife called me frantically while on the road to say "all went dark, except check engine light came on". After couple of minutes, gauges came back and all seemed normal..until next time we tried to start. Car fired up but died immediately three times, then stopped cranking also. Battery voltage is good, and when it cranked, it did so with authority. All...
28 Posts. Last post send by: Norm II - Thursday 26 Jun
From: Brettster - 26 Jun 2008, 04:11
I have a 1994 Jeep Grand Cherokee Laredo. Start the engine, sounds fine. Then, after a few moments, there's a terrible rattle. No performance problems, just bothersome. You can hear the sound fairly well on the video: http :// www .youtube,com /watch?v=ScNkXfnYB1M What's causing this knocking/rattling noise? Any ideas? How much will it cost to repair...
3 Posts. Last post send by: Brettster - Thursday 26 Jun
From: Piperson - 26 Jun 2008, 01:39
1999 T&C Limited. Emergency and turn signals work all around except the front right. Of course the right rear flashes at double speed. Ground check fine, but no power is getting to the new or swapped bulbs. There does not seem to be any undue wear or damage to the harness in that area, but I can't tell where it goes after entering the engine compartment...
0 Reply
From: Ed - 25 Jun 2008, 18:30
http :// easyurl,net /ChryslerCertified
0 Reply
From: Even Stephen - 25 Jun 2008, 03:51
I have a 2003 PT Cruiser. Recently, while stopped for gas, I heard a loud hiss under the front of my PT and saw a cloud of steam shoot out near the front. I opened the hood and checked for a hose leak and checked the water level and all seemed well. Does the PT have a pressure relief valve?
2 Posts. Last post send by: Even Stephen - Wednesday 25 Jun
From: Even Stephen - 25 Jun 2008, 03:31
I have a 2003 PT Limited Edition and the air condenser seems to kick in and out frequently and cause a a vibration like the engine might be missing. My '98 Grand Prix has air also and I've never noticed it acting in this manner. Should I have the PT air unit checked?
3 Posts. Last post send by: Even Stephen - Wednesday 25 Jun
From: Dr. David Zatz - 24 Jun 2008, 07:06
Archive-name: autos/chrysler-faq/general/part1 Posting-Frequency: 15 days Last-modified: 2007/6/26 Version: 6 This section is generally revised every 300 days. - - - - - - - - - - - - IMPORTANT. Do not attempt to respond to faq@allpar,com . Due to spam this address DOES NOT GO ANYWHERE. Instead, go to allpar,com and provide feedback from there. ...
1 Posts. Last post send by: Dr. David Zatz - Tuesday 24 Jun
