Group: rec.autos.makers.chrysler
Dodge, Plymouth, Jeep, Eagle, etc info/talk.
Add group to favorites
Back to group list
Send new message to group Search:
From: kllewis2 - 11 Aug 2008, 16:22
Error 37 code after 5 hours of highway speed (Torque Converter Clutch Solenoid circuit An open or shorted condition detected ) -- Posted at author's request, using moderated http :// www .AutoBoardz,com interface Thread archive: http :// www .AutoBoardz,com /1998-Plymouth-Neon-ftopict248446.html
0 Reply
From: hoff - 11 Aug 2008, 15:24
I need to find a link to show me how to adjust the linkage in a 2000 plymouth neon. The gearshift cable was taken off the transmission housing for other repairs. When it was put back on and the car was shifted into reverse, it went forward. The other forward gears also worked. I need to figure how to properly hook up this cable on the transmission housing....
0 Reply
From: Rick_T - 11 Aug 2008, 15:23
I have a difficult no-start problem on a 1994 Dodge Intrepid 3.3L. Any suggestions would be appreciated. As reported to me, the car was running when the engine suddenly died; then no-start. So far: No codes No check engine light at all, even during the initial seconds after the key is put into the on position No spark Cam and crank sensors check out...
1 Posts. Last post send by: Rick_T - Monday 11 Aug
From: kllewis2 - 11 Aug 2008, 15:23
Error 37 code after 5 hours of highway speed (Torque Converter Clutch Solenoid circuit An open or shorted condition detected ) How long do I have or what should do? -- Posted at author's request, using moderated http :// www .AutoBoardz,com interface Thread archive: http :// www .AutoBoardz,com /Error-code-37-1998-Plymouth-Neon-ftopict248447.html
0 Reply
From: rgregory189 - 11 Aug 2008, 15:23
my 03 jeep wrangler will start shaking at around 50+ mph. not all the time, but when it starts i have to slow down for it to stop. just had tires rotated and balanced but didn’t help. any ideas -- Posted at author's request, using moderated http :// www .AutoBoardz,com interface Thread archive: http :// www .AutoBoardz,com /help-wrangler-ftopict248425.ht...
1 Posts. Last post send by: rgregory189 - Monday 11 Aug
From: Dan'L - 11 Aug 2008, 15:01
I am almost ready for a new set of brake pads on the front of my 2004 Dodge Dakota Quad Cab 4X4. Because it's difficult to keep the wheels half-way clean, due to the current pads, (supposedly OEM equivilents, according to my local Meineke Dealer, who installed them, about 20,000 miles ago), so I'm looking toward spending a few extra dollars for some ceramic...
3 Posts. Last post send by: Dan'L - Monday 11 Aug
From: Jim Higgins - 11 Aug 2008, 14:07
Chinese cars you could soon see in the U.S. http :// www .msnbc.msn,com /id/26075484/ Don't be surprised if your next car has a "Made in China" label on it. As the world focuses on the XXIX Summer Olympic Games in Beijing, Chinese automakers are looking beyond their borders. They aim to sell vehicles in North America, one way or another. "It's definitely...
4 Posts. Last post send by: Jim Higgins - Monday 11 Aug
From: drishaq - 10 Aug 2008, 13:42
What does your GPS really think about you? http :// www ,fr eegpsguide.info/2007/12/what-gps-thinks.html
0 Reply
From: Jerry - OHIO - 09 Aug 2008, 07:47
Trying to remove rear brake drums . Do they come off like other cars or do I have to remove the large nut under the grease cap on the axel ?? The front rotors came off with out removing the center nut I hope back drums are the same. I beat on the drums but I wasn't sure if thats how they come off. Any help will be appreciated. Jerry
4 Posts. Last post send by: Jerry - OHIO - Saturday 09 Aug
From: Dr. David Zatz - 09 Aug 2008, 07:18
Archive-name: autos/chrysler-faq/general/part1 Posting-Frequency: 15 days Last-modified: 2007/6/26 Version: 6 This section is generally revised every 300 days. - - - - - - - - - - - - IMPORTANT. Do not attempt to respond to faq@allpar,com . Due to spam this address DOES NOT GO ANYWHERE. Instead, go to allpar,com and provide feedback from there. ...
1 Posts. Last post send by: Dr. David Zatz - Saturday 09 Aug
From: Josh S - 09 Aug 2008, 04:25
I've decided to get a low mileage 300M, preferably years 2004 or 2003. With the current gas price fears their selling value has crashed. With such low depreciation I can afford the expensive gas and enjoy that lovely car. I've seen a very good condition low mileage (40k miles) 2000 and an unbelievably low price, but I'm passing on it because of age. If...
25 Posts. Last post send by: Josh S - Saturday 09 Aug
From: N9NEO - 08 Aug 2008, 19:55
Greetings. My Daughter's car was hard starting, and now totally dead. My daughter's mechanic told me he has to change the spark plug seals. (He told me the plugs go traight through the valve covers - that's the way they are on my brother's 67 belvedere.) He told me he has to take the intake manifold off to get tot the back three seals. Is this correct?...
13 Posts. Last post send by: N9NEO - Friday 08 Aug
From: Jim Higgins - 07 Aug 2008, 20:27
Chrysler Nissan Deal: One More Step To Oblivion For Chrysler? http :// tinyurl,com /6ka3xv The Wall Street Journal today published a story stating, according to un-named sources, that Chrysler is in talks with Japanese automaker Nissan to essentially supply the Auburn Hills, MI carmaker with mid-sized cars derived from the Nissan Altima. Such a deal...
2 Posts. Last post send by: Jim Higgins - Thursday 07 Aug
From: kinnamon.lindsay@gmail,com - 07 Aug 2008, 00:55
I am currently leasing a Jeep Wrangler. My lease expires at the end of September and in my contract it states I have to pay a vehicle turn- in fee of $425. Because Chrysler has decided to no longer lease their vehicles, as well as other reasons, I do not plan to buy another Chrysler when my lease is up. Has anyone else been able to negotiate with Chrysler...
5 Posts. Last post send by: kinnamon.lindsay@gmail,com - Thursday 07 Aug
From: admin@ng2000,com - 05 Aug 2008, 14:08
http :// www .ng2000,com /fw.php?tp=chrysler 08/05/2008: After a year with Cerberus, industry analysts say Chrysler faces a bumpy road that could include a future sale of part or all of the automaker.
19 Posts. Last post send by: admin@ng2000,com - Tuesday 05 Aug
