Add group to favorites
Back to group list
Send new message to group Search:
From: chrisbirch57@hotmail,com - 08 Dec 2006, 03:06
my engin light stays on and millage is lousy was going to ream out or replace catalitic and also o2 sensor but dont know where its at. any body know where and have you ever replaced it?
2 Posts. Last post send by: chrisbirch57@hotmail,com - Friday 08 Dec
From: jwalrond1@bellsouth,net - 07 Dec 2006, 08:51
OK I know it needed it even though no bad signs or sounds. I changed the trans fluid and filter,it was due. Also drained the transfer case and changed the fluid. Used Mercon V as the manual stated. Started off to work the next day and as I slowed down it jumped out of gear started slipping. I could stop put it back in drive and it drove a couple miles then...
4 Posts. Last post send by: jwalrond1@bellsouth,net - Thursday 07 Dec
From: Jay1028 - 06 Dec 2006, 00:22
I want to be able to listen to the radio and have the drivers door open. Of course, the chiming is annoying. I don't see a old style pin switch to depress to stop the chiming. Where is the switch? I don't want to disable the chime because it comes in handy for the parking/headlight mionder. Jay
1 Posts. Last post send by: Jay1028 - Wednesday 06 Dec
From: julie byrd - 05 Dec 2006, 22:14
after driving through some high water the next day my explorer began squeaking around the front end, i havent been able to find any zerk or grease fittings any body have any ideas? thanks in advance mark miller
4 Posts. Last post send by: julie byrd - Tuesday 05 Dec
From: ndccpf1@gmail,com - 05 Dec 2006, 13:53
No grinding just hard to get into gear with clutch all the way down. While at a stop, effort is less if you go from 2nd to 1st gear then let out the clutch. My syncros ? Trans oil and rear diff oil have recently been changed and there is no difference.
5 Posts. Last post send by: ndccpf1@gmail,com - Tuesday 05 Dec
From: Uncle Albert - 05 Dec 2006, 08:04
Hello All. I tried to start my Explorer last night. The engine turned, but it didn't start. I tried again. The engine didn't start either, but this time smoke came from under the hood. It wasn't an electrical fire, but had the odor of unburnt gas. I checked under the hood. Everything looked OK. The engine started this time. After the engine rpm reached...
3 Posts. Last post send by: Uncle Albert - Tuesday 05 Dec
From: tigerweeds - 04 Dec 2006, 16:44
94 XLT, speakers are crackling even after changing unit. Can this be a built in amp that is causing problem,. If so,, can a backyard mechanic like myself fix it by getting one from the wreckers, please help, my teenage daughter is going to bonk me if I don't fix it lol. thanks.
6 Posts. Last post send by: tigerweeds - Monday 04 Dec
From: Bill Jeffrey - 03 Dec 2006, 19:41
Re: The radio with 6-disc CD changer in my '02 Explorer. This unit has worked well since Day 1, until recently when the audio developed a kind of frog-in-the-throat distortion. Since the problem happened on all four channels simultaneously, I don't think I've blown a speaker, nor have I popped an amplifier output stage, nor is it a wiring problem....
1 Posts. Last post send by: Bill Jeffrey - Sunday 03 Dec
From: kalpanaali@yahoo,com - 01 Dec 2006, 20:57
What to buy ? a 4 cyl SUV ? My sister lives in the San Fran Bay Area, CA. She has 2 children who are 16 and 14. So they are quite tall. She is looking for a 4 cylinder SUV that will accomodate her kids comfortably in the rear seat. She does not need a 4x4 / all AWD. She was told that she would have to buy 6 or 8 cyl SUVs if she wants more leg room...
3 Posts. Last post send by: kalpanaali@yahoo,com - Friday 01 Dec
From: John B. - 01 Dec 2006, 14:52
I have a '98 Explorer and after a shop visit, was told I have mice living in it. (As I mainly walk to work, it sits for days at a time.) There were no obvious signs of the critters except the mechanic smelling mice urine while inside. Anyone ever have this problem with their Explorer? If so, where would be the places in the vehicle that they would most...
5 Posts. Last post send by: John B. - Friday 01 Dec
From: Sevenpelicans@hotmail,com - 01 Dec 2006, 03:26
Hello, I have recently been tuning up my 93 ford explorer xlt. I got a code reader and did the KOEO test and the code 33 came up. Now I am a little confused as it came up as follows *-*-*----*-*-*---------------*-*-*---*-*-* from the reader. Some one told me that I maybe reading this wrong and really I am getting 111 several times which could mean that...
1 Posts. Last post send by: Sevenpelicans@hotmail,com - Friday 01 Dec
From: Jack Zwanenburg - 30 Nov 2006, 20:30
I have a 1993 ford explorer and the vehicle was envolved in a collision and there is an emergency fuel shut off switch. There is also a reset button and I need to know where it is located.
2 Posts. Last post send by: Jack Zwanenburg - Thursday 30 Nov
From: JM - 30 Nov 2006, 10:47
My explorer has 80,000 and recently I have notice a low pitched noise from the rear of the truck. It varies with speed and it's not very loud. It may be a wheel bearing or something else. Anyone else had a similar problem? How do you find if there has been a service notice or recall? Thanks for any help. Jim
5 Posts. Last post send by: JM - Thursday 30 Nov
From: estella - 30 Nov 2006, 08:22
Private car owners, are you selling your used car? If you are, you can now enjoy your vehicle listing on the market through online with our friendly private listing service just for free and there'll be no hidden charges. And if you are buying we also have the lists for you to choose from! Visit http :// cars.ozfreeonline,com
0 Reply
From: brad - 28 Nov 2006, 23:42
i have a 97 explorer and we just had a 18inces of snow..so i put her in 4wheel auto and now the 4wheel auto and 4wheel low lights are flashing, any ideas??
2 Posts. Last post send by: brad - Tuesday 28 Nov
